37
HARNESS COVERS
NEWBORN INSERT (REAR-FACING ONLY)
• To ensure a better fit for smaller infants, the Newborn Insert may be
needed. DO NOT use any other infant insert or pillows.
Only use the one provided by CYBEX for this Child Restraint.
• Pull Harness Buckle through slot in the bottom of Newborn Insert.
• Pull both Harness Straps over the side panels of Newborn Insert.
• Push Newborn Insert firmly into Child Restraint to make sure it is
properly positioned.
• When positioning the headrest make sure the bottom of the headrest
flap is behind the infant insert flap.
Install harness covers above chest clip. Harness covers are optional
for comfort. Wrap harness covers around harness straps and fasten the
snaps.
ALWAYS make sure the harness covers DO NOT bunch up when
tightening the harness.
CHILD RESTRAINT FEATURES
To Next Page
Loading...
Need help?
General
