47
6 / TROUBLESHOOTING
ERROR CODE NUMBERS
1: NO SPEED SIGNAL AT STARTUP
2: EXCESSIVE CURRENT DRAW
3: LOSS OF SPEED SIGNAL
4: NO FREQUENCY LOCK
5: ELEVATION ERROR
6: OVERSPEED
7: LOSS OF NOVRAM
Only one error code from the log can be displayed at any time. To
scroll through the Error Log, use either the speed or the elevation keys.
All errors will cause the treadmill to be inoperative. Power must be
cycled on and off to resume usage. If errors recur, the treadmill will
again be inoperative.
Active keys during this test:
START/ENTER will save settings and advance you to the next
diagnostic test.
STOP will exit and return you to the mode you were in before
entering the diagnostic tests.
SHIFT backs you up one step in the diagnostics test menu.
The - and + keys cycle you through the Error codes.
The ▼ and ▲ keys cycle you through the Error codes.
d12: LOG CLEAR
(ERROR LOG & MAINTENANCE PROMPT CLEAR SWITCH)
This test allows you to clear (erase) all the error codes in the Error
Log and/or to clear (turn off) a Maintenance Prompt. In this test, the
left window displays the error set message (ErrS), and the right
window shows the Maintenance Prompt set message (nnS).
Example 1:
ErrS nnS
To clear the Error Log, press the ▲ key, and the left window will
display the error clear command (Err C).
To turn off a Maintenance Prompt, press the + key, and the right
window will display the Maintenance Prompt clear command (nnC).
Example 2:
ErrC nnC
Press START to accept the clear command(s) and advance to d1.
Active keys during this test:
START/ENTER will accept the displayed state of the Error Log and
Maintenance and advance you to the first diagnostic test.
STOP will accept the displayed state of the Error Log and
Maintenance Prompt and will exit and return you to the mode you
were in prior to entering the diagnostic tests.
SHIFT accepts the displayed state of the Error Log and
To Next Page
Loading...
Need help?
General
