CYBEX Arc Trainer 620A User Manual

Preventive
Maintenance
Page 4-4
B. Remove the two upper screws securing the
access cover. See Figure 2.
C. Remove the access cover.
! WARNING: The flywheel may be hot. Wait until it
cools before servicing.
4. Check the condition of each belt.
A. Roll each belt by pulling down on it. Examine the
condition of each belt. If a belt has cracks or
appears worn, it must be replaced immediately
by a qualified service technician.
5. Attach the access cover.
A. Using a Phillips head screwdriver, tighten the
two upper screws first (removed in step 3B).
NOTE: Do not over tighten screws.
B. Tighten the two lower screws, removed in step
3A. NOTE: Do not over tighten screws. See
Figure 2.
6. Test unit for proper operation.
Figure 2
Screw (4)
Access
Cover
Cybex Arc Trainer 620A/629A Owner’s Manual

CYBEX Arc Trainer 620A Specifications

General

Brand	CYBEX
Model	Arc Trainer 620A
Category	Fitness Equipment
Language	English