EasyManuals Logo

CYBEX V Series User Manual

CYBEX V Series
23 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #9 background imageLoading...
Page #9 background image
Do not stand or sit on plastic shrouds.
Use caution when mounting or dismounting the bike. Use the stationary handlebar whenever additional stability
is required.
Cross-Trainer
Warning: Ensure that there is at least 1 ft. (0.3 m) of clearance in front of the Cross-Trainer and at least 2 ft.
(0.6m) on the side.
Warning: The Cross-Trainer is not equipped with a free-wheeling feature. Therefore, the product cannot
be stopped immediately.
Do not stand or sit on the rear plastic covers of the Cross-Trainer.
Do not stand on center tube of the Cross-Trainer.
The individual human power required to perform an exercise may be different than the mechanical power
displayed on the Cross-Trainer.
Use caution when mounting or dismounting the Cross-Trainer. Before mounting, use the moving arms to bring
the pedal nearest to you to the lowest position. Use the stationary handlebars whenever additional stability is
required. While exercising, hold onto the moving arms.
Never face backward while using the Cross-Trainer.
Treadmill
Caution: Risk of injury to persons to avoid injury, use extreme caution when stepping onto or off of a
moving belt. Read assembly instruction manual before using.
Warning: Keep the area 6.5 ft. (2 m) by 3 ft. (0.9 m) behind the treadmill clear of any obstructions, including
walls, furniture,and other equipment.Contact Customer SupportServices for an optionallonger power cord
if necessary.
Warning: Be sure the emergency stop lanyard is clipped to the user and in proper position on the treadmill
before beginning any workout.
Warning: The belt centering adjustment must be performed if the belt is not between the marks indicating
the maximum allowed lateral positions. Refer to Treadmill Assembly Instructions.
The product should never be left unattended when plugged in. Disconnect from the electrical outlet when not
in use, and before putting on or taking off parts. To disconnect, turn power OFF at the ON/OFF switch, then
remove plug from electrical outlet.
Keep the power cord away from heated surfaces. Do not pull the equipment by the power cord or use the cord
as a handle.
Handrails may be held to enhance stability as needed, but are not for continuous use.
Never mountor dismount the treadmillwhile the running belt is moving. Usethe handrails whenever additional
stability is required. In case of an emergency, such as tripping, grasp the handrails, and place the feet on the
side platforms.
Never walk or jog backwards on the treadmill.
Do not use this product in areas where aerosol spray products are being used or where oxygen is being
administered. Such substances create the danger of combustion and explosion.
In conformity with the European Union Machinery Directive 2006/42/EC, this equipment unloaded runs at sound
pressure levels below 70 dB (A) at the average operating speed of 12 km/hr. Noise emission under load is higher
than without load.
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
Page 9 of 23

Other manuals for CYBEX V Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the CYBEX V Series and is the answer not in the manual?

CYBEX V Series Specifications

General IconGeneral
BrandCYBEX
ModelV Series
CategoryTreadmill
LanguageEnglish

Related product manuals