Assembly
Page 4-1
Cybex VR1 Owner’s Manual
4 - Assembly
NOTE: Two people will be required to perform this procedure.
NOTE: It is the responsibility of the facility owner/owner of the equipment to ensure that there is
appropriate clearance around each machine to allow for safe use and passage.
NOTE: Refer to Chapter 6 for reference diagrams.
1. Read and understand all instructions thoroughly before assembling this product.
2. Verify you have received the appropriate confi guration.
Verify that you received the correct color machine that you ordered.A.
Verify you received the proper weight stack and weight stack decals. B.
Verify you received the appropriate owner’s manual.C.
Verify you received the warranty sheet.D.
3. Move to desired location.
NOTE: If weight stacks need to be removed before moving to desired location proceed to step 7.
NOTE: If weight stacks need to be installed proceed to step 8.
4. Remove shipping feet.
Warning: Use extreme caution when removing shipping cones and installing feet.
Failure to do so could result in injury.
With an assistant, carefully remove each (standard) cone-shaped shipping support using a 3/4” A.
socket or wrench.
Carefully place rubber feet (supplied with machine) on each foot of the frame.B.
NOTE: It is important that you perform regular inspection and maintenance activities on your
equipment. See the CYBEX VR1 Owner’s Manual for inspection and maintenance activities.
If you do not have a CYBEX Owner’s Manual or if you have any questions or concerns, Call
Cybex Customer Relations at 888-462-9239.
7/32” Allen wrench
•
3/4” Socket or wrench•
Hammer•
3/16” Pin punch•
Tools Required
To Next Page
Loading...
Need help?
General
