4
© 2023 CYC MOTOR LTD
Inspect all electrical wires and plugs for damage regularly.
Secure all wires properly. Ensure that the throttle can bet twisted freely without friction and that
the throttle can return to its original position without restriction. This is to prevent any
uncontrolled response of the system.
Installation & Use
Do not install anything other than the parts and accessories that came with this drive unit. Doing
so could damage the product.
The drive system can be activated and deactivated by holding down the ON/OFF button of the
display.
Avoid changing the bike gear (note: this is different from the drive unit’s assist level) while the
drive unit is powering the bike. This may lead to excessive wear on the chain and chain rings or
other gear related failure. When changing gears, use human input only. After the gear is changed,
you may accelerate again with the throttle or continue using the PAS.
Take off with the appropriate assist level and bike gear.
This product is splash proof and rain proof but not waterproof. Do not submerge it underwater.
Disclaimer
If you require any more information or have any questions about the user manual disclaimer,
please feel free to contact us via email at support@cycmotor.com or call +852-3690-8938.
All the information contained in this manual is published in good faith and for general
informational purposes only. CYC MOTOR LTD does not make any warranties about the
completeness of this information and encourages further inquiries If needed. CYC MOTOR LTD will
not be held liable for any losses and/ or damages in connection with the use of this product. The
use of this product is at own risk.
To Next Page
