Page 17
THROTTLE SETTINGS AND DEFAULT VALUES
ACCESS THROTTLE SETTINGS:
To enter and exit throttle settings, hold down both buttons (M/Mode) and
(Power) at the same time until you get into the mode settings and also to
exit the mode settings.
Press (Power) to go to the next mode level of the parameter.
Press (M/Mode) to increase the setting parameter.
Press (Power) to decrease the setting parameter.
Press and hold (M/Mode) to set the chosen parameter.
Press and hold (M/Mode and Power Button) together to lock the chosen
parameter, then turn the throttle o and then back on again.
Note: The CycleBoard throttle only has 1 Mode button. In order to
decrease your speed mode, you must cycle through the speed modes
to get to the lower speed mode.
THROTTLE P PARAMETERS:
P01: Backlit Brightness
(1) Darkest (2) Medium (3) Brightest
P02: Distance Unit
(0) km/h (1) mph
P04: Throttle Auto Shuto
(0) Don’t Shuto (1) – 0-60 (Unit Minutes)
P15: Program Speed Limits per speed mode
Unit mph / km/h (unit = 0-100%)
P16: Cruise Control
(0) O (1) On
ALWAYS KEEP IN THE OFF 0 POSITION,
DO NOT TURN TO THE ON 1 POSITION
P99: Factory Restore
Long press Mode button for 5-6 seconds
MULTIFUNCTION DISPLAY:
To change between ODO, TRP, RM, and ERROR display, press the
(Power) button.
P15: PROGRAM SPEED LIMITS PER SPEED MODE
This parameter allows you to decrease the top
speed of the 5 speed modes by inputting a
percentage less than 100. For example: an input of
50 will limit the top speed of each of the 5 speed
modes to 50% of the listed speed.
To Next Page
Loading...