EasyManuals Logo

CycleOps PowerTap User Manual

CycleOps PowerTap
41 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #35 background imageLoading...
Page #35 background image
HHUUBB BBAATTTTEERRIIEESS
Normal battery life in the hub is 400 hours of actual ride time.Use #357 or EPX76 Silver Oxide
type batteries and always replace batteries in pairs.Alkaline type batteries give shorter life and
poorer performance.NOTE:After replacing batteries in the hub you need to Learn the device
codes.See computer setup 5.
BBAATTTTEERRYY RREEPPLLAACCEEMMEENNTT
- Unscrew the plastic battery cover.Use a spanner wrench or bench vise opened wide to get it
started if stuck.There are O-ring seals that can cause the cover to resist the start of motion.The
threading is normal right hand.
- Remove the battery pack.A small screw driver can be used back and forth between the to ends
to start to lift it out.
- Pop the battery out by bending the plastic retaining tap back and pushing the batter up from
the bottom.
- Check that the electrical connector tab from the inside of the hub is perpendicular to the
bottom of the battery pocket.If the tab gets bent,gently press it back to perpendicular with
a non-sharp tool.
-Slide the battery pack back into position along the center core.As the battery is engaged a small
increase of resistance to installation should be felt as the electrical connections are made.
- Thread the cap all the way back on.
- Replacement O-rings and battery packs are available from Saris Cycling Group.
35

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the CycleOps PowerTap and is the answer not in the manual?

CycleOps PowerTap Specifications

General IconGeneral
BrandCycleOps
ModelPowerTap
CategoryBicycle Accessories
LanguageEnglish

Related product manuals