CyClone Elliptical Trainer - Page 6

ASSEMBLY INSTRUCTIONS
STEP 6
Install four "C" size batteries into the COMPUTER(33), four batteries included. Plug the
UPPER CONNECTION WIRE(32) into the COMPUTER(33). Then attach the COMPUTER(33) onto
the plate
on the
UPRIGHT(4) with ROUND HEAD SCREWS(M5 x 10mm)(61). Press the
READING HOLDER(34) into the COMPUTER(33).
STEP 7
Attach the STATIONARY HANDLEBAR(5) onto the UPRIGHT(4) with FLAT HEAD
BOLTS
(M6 x 40mm)(70). Plug the PULSE PLUG WIRE(35) into the back of the COMPUTER(33).
6