OVERRIDE
The system can be overridden by means of a Personal Identification Number (PIN). Every unit is supplied
with its own PIN. It is important to make a note of this PIN or keep the card supplied with the unit in a safe
p1ace as it also has the PIN detailed on it.
** Any digit marked '0', indicates 10 flashes.
OVERRIDE PROCEDURE
! Insert the ignition key into the ignition switch and turn to the ON position. The red status LED mounted on
the dash will glow constantly.
! Turn the ignition key back to the ACC position, the status LED will begin to flash slowly. Count the number
of flashes for the first digit in the PIN of the P275. Return the key to the ON position when the correct
number is counted.
Repeat step 2 for the remaining digits in the PIN. When all four digits are entered, the indicators / status LED
will flash once, the P275 will then disarm. NB: If the engine is not started with 40 seconds of over-riding,
the P275 with immobilise the engine.
PROBLEM SOLVING
Unit won't arm/disarm
! Make sure that ignition switch is in the OFF position.
! Make sure the vehicle battery is not flat.
! Try your spare remote transmitter unit.
- 4 -
To Next Page
