To Next PageTo Next Page
Need help?Do you have a question about the Cylink 303F and is the answer not in the manual?
Instructions for installing a SIM card into the tracker device for GSM network.
Steps to power on the tracker, connecting to car power and backup battery.
Explains the meaning of Red and Green LED lights for GSM and GPS status.
Resets the tracker to factory defaults and allows changing the default password.
Manages authorized phone numbers and retrieves single location reports.
Configure timed location reporting with a specific number of repetitions.
Set continuous location reporting at intervals, varying by ACC status.
Combine time and distance triggers for location updates.
Options for immediate engine stop or stop at lower speeds.
Command to restore engine oil and power supply after it was cut off.
Controls for ARM, DISARM, Silent Mode, SOS, and Deterrence/Car Search functions via remote.
How to arm the tracker using SMS commands, with conditions.
How to arm the tracker using the optional remote controller.
Instructions to enable silent mode via SMS commands.
Instructions to enable silent mode using the optional remote controller.
How to disarm the tracker using SMS commands.
How to disarm the tracker using the optional remote controller.
Notifies authorized numbers when the tracker's battery voltage is low.
Alerts when the external power source to the tracker is disconnected.
Notifies when GPS signal is lost, providing last known coordinates.
Sends an emergency alert with location to authorized numbers when the SOS button is pressed.
Sets up virtual geographic boundaries and alerts when the tracker exits them.
Defines, renames, and removes geographic areas for monitoring and alerts.
Enables or disables alerts for entering or exiting defined geographic areas.
Notifies when a door is opened while the tracker is in ARM state.
Notifies when the ignition (ACC) is turned on while the tracker is in ARM state.
Configures the sensitivity levels for detecting vibrations or shocks.
Puts the tracker into sleep mode based on a specific time interval or inactivity.
Enters sleep mode when no vibration is detected and ACC is off.
Activates a very low power deep sleep mode, awakened by triggered alarms.
Disables all sleep modes, keeping GSM, GPS, and LED active.
Configures the Access Point Name (APN) for GPRS network connection.
Sets up username and password for GPRS login if required by the network.
Configures the IP address and port number for GPRS data transmission.
Switches the tracker's communication mode to GPRS.
Selects the communication protocol (TCP or UDP) for GPRS data.
General