EasyManua.ls Logo

Cylink 303F - Silent Mode Configuration; Set up silent mode by SMS; Set up silent mode by remote controller; Disarming the Tracker

Default Icon
22 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
14
If the car is in ignition (ACC is at “ON” position), then the car can’t enter ARM state, and siren keep
silent.
If engine turned off, but door is open, then the car can’t enter ARM state and siren beeps 3 times, that
means door is not closed.
Silent Mode
Set up silent mode by SMS
Send silent+password to tracker, it will reply silent ok! that means tracker enters ARM & silent
mode, Siren won’t be sound after alarm is triggered
, but tracker will send alarm SMS to authorized number.
Send disarm+password to quit ARM & silent mode.
Set up silent mode by remote controller (Option for model G)
Press in disarm state for 0.5 second, the siren will beep one time, the car will enter ARM &
Silent mode. Siren won’t be sound after alarm is triggered, but tracker will send alarm SMS to
authorized numbers.
Press
to quit.
DISARM
DISARM BY SMS
Send command “disarm+password” to tracker, tracker will disarm and reply “Tracker is deactivated”,
then it will turn off the alarm of door, shock sensor and ACC, and no alarms if open door, trigger
shock sensor and ignition.
DISARM BY Remote controller (Option for model G)
Press
on remote controller for 0.5 seconds, the car will enter DISARM state and, siren beeps
two times and tracker doesn’t send message.
Decide how many times of alarm message
You can decide how many times of the alarm message to be sent, For those alarm message sent in
cycle, you can limit the times the alarm message to be sent. send SMS xtime+password+005 to
tracker, alarm message will be sent 5 times once alarms are triggered .
The Alarm SMS will be sent 5 times by default.