EasyManua.ls Logo

Cylink 303F - Start Work on specific time; Check the Vehicle State; Check IMEI; Set up Terminal (local) Time

Default Icon
22 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
19
Start Work on specific time
Send "schedule+password+space+1h"to tracker, it will awake every one hour and send position info.
(m:minute,h:hour,d:day) The time interval is in 3 digits at most and should be less than 30days.
GSM & GPS module shut off, trackers work under low power consumption mode. Neither calling nor
SMS can awake tracker device. Track will be awaken by alarms and enter to this mode after alarms
are deactivated.
Cancel: After the tracker is waked up. Send SMS command” noschedule+password”to cancel this
function.
Check the Vehicle State
Send SMS command “check+password” to the tracker device in the vehicle, It will reply the status
of the power, battery, GPS, ACC, door, GSM signal, GPRS status ,oil, APN, UP, IP and Port.
For example: Send SMS “check123456” to the tracker device in the vehicle, It will reply following
SMS.
Power: ON/OFF
Battery: 100%
Oil: 100%
GPRS: ON/OFF
GPS: OK/NO GPS
ACC: OFF/ON
Door: OFF/ON
GSM Signal: 1-32 The higher, the better.
APN: cmnet
IP: 104.250.138.146
PORT: 9000
Check IMEI
Send SMS command "imei+password" to the unit. E.g. Send SMS command "imei123456" to the
tracker device, an IMEI number in 15 digits will reply to your cell phone.
Set up Terminal (local) Time
Send SMS command “time+space+zone+password+space+time” to the tracker unit, If succeed, It will
reply “time OK”