Multi-area management
Set area
Send SMS command "area+password+space+latitude,longitude+space+areaname,distanceM" to
tracker(distance unit: M for meter, K for kilometer), it will reply "area01 ok". For Example: Send
"area123456 22.353648,113.543678 school,800M".
Note: 5 areas at most and the distance between two points can't be less than the total distance in the 2
commands, and different areas can't cover each other
Delete area
Send SMS command:"noarea+password+space+area name” to tracker, it will reply:"noarea ok".
rename and set distance
Send SMS command "rename+password+space+old name;new name,distanceM" to tracker, if name
is not repeated and area doesn't cover others, it will reply "rename ok!" for successful configuration.
Example: Send"rename123456 area01;school,800M", it means the new area name is "school", and covers
area of a radius of 800 meters.
Activate multi-area management
Send SMS command "area+password+space+on" to tracker, it will reply "Area on ok!", when tracker
enter the pre-set area, it will send SMS "area name+latitude & longitude" to all the authorized phone
number, and send same SMS when goes out of the area.
Deactivate Multi-area management
Send SMS command "area+password+space+off" to tracker, it will reply"area off ok!
Movement alarm
Set up: when the unit stays immobile in a place for 3-10 minutes with GPS signal reception, the user can
send SMS“move+password+space+0200” to the tracker (Suppose area of a radius of 200 meters, it
supports 4 digits at most. Unit: Meter). It will reply “move OK”. In case of such a movement (the default
distance is 200m), it will send SMS “Move+ latitude & longitude” to the authorized numbers at interval of
3 minutes.
Cancel: Send SMS “nomove+password” to deactivate the movement alarm.
Overspeed alarm
Set up: Send SMS command “speed+password+space+080” to the unit (suppose the speed is 80km/h),
and it will reply “speed OK!”. When the target moves exceeding 80km/h, the unit will send SMS
To Next Page
Loading...