CYP CH-U331RX - Receiver and Serial Commands

14
4. Transmitter Specic
COMMAND DESCRIPTION AND PARAMETERS
SET_VW_SHIFT N1 N2 {N3} Set the video wall display’s output
shift.
Available values for N1:
U [Shift up]
D [Shift down]
L [Shift left]
R [Shift right]
N2 = 0~80000 [Pixel shift amount.
Must be in increments
of 8.]
N3 = 0~255 [Target Rx {Optional}]
Note: Target Receiver number can
be obtained by turning on the Video
Wall OSD. Omitting N3 makes the
settings global to all Receivers.
SET_VW_DELAY N1 {N2} Set the video wall display delay.
N1 = 0~99999 [Delay in
microseconds]
N2 = 0~255 [Target Rx {Optional}]
Note: Target Receiver number can
be obtained by turning on the Video
Wall OSD. Omitting N2 makes the
setting global to all Receivers.
5. Receiver Specic
COMMAND DESCRIPTION AND PARAMETERS
SET_EDID_COPY N1 Copy and use the EDID of the
connected display.
Available values of N1:
0 [Disabled]
1 [Enabled]
GET_EDID_COPY Show the state of the EDID copy
function.