CYP CH-U331RX - Page 17

13
4. Transmitter Specic
COMMAND DESCRIPTION AND PARAMETERS
SET_VW_BC N1 N2 N3 N4 {N5} Set the video wall display’s bezel
compensation values.
N1 = 0~99999 [Video width]
N2 = 0~99999 [Total display width]
N3 = 0~99999 [Video height]
N4 = 0~99999 [Total display height]
N5 = 0~255 [Target Rx {Optional}]
Note: Target Receiver number can
be obtained by turning on the Video
Wall OSD. Omitting N5 makes the
settings global to all Receivers.
SET_VW_HSCALE N1 {N2} Set the video wall display’s horizontal
zoom amount.
N1 = 0~99999 [Zoom amount in 1
pixel units]
N2 = 0~255 [Target Rx {Optional}]
Note: Target Receiver number can
be obtained by turning on the Video
Wall OSD. Omitting N2 makes the
setting global to all Receivers.
SET_VW_VSCALE N1 {N2} Set the video wall display’s vertical
zoom amount.
N1 = 0~99999 [Zoom amount in 1
pixel units]
N2 = 0~255 [Target Rx {Optional}]
Note: Target Receiver number can
be obtained by turning on the Video
Wall OSD. Omitting N2 makes the
setting global to all Receivers.