CYP CH-U331RX - Page 16

12
4. Transmitter Specic
COMMAND DESCRIPTION AND PARAMETERS
Note: Target Receiver number can
be obtained by turning on the Video
Wall OSD. Omitting N2 makes the
setting global to all Receivers.
SET_VW_LAYOUT N1 N2 {N3} Set the video wall’s total horizontal
and vertical display count.
N1 = 1~16 [Horizontal display
count]
N2 = 1~16 [Vertical display
count]
N3 = 0~255 [Target Rx {Optional}]
Note: Target Receiver number can
be obtained by turning on the Video
Wall OSD. Omitting N3 makes the
settings global to all Receivers.
SET_VW_POS N1 N2 {N3} Set the display’s position within the
video wall. (Cannot exceed the
video wall’s horizontal and vertical
display count.)
N1 = 0~15 [Row]
N2 = 0~15 [Column]
N3 = 0~255 [Target Rx {Optional}]
Note: Target Receiver number can
be obtained by turning on the Video
Wall OSD. Omitting N3 makes the
settings global to all Receivers.