CYP CH-U331RX - Page 15

11
4. Transmitter Specic
COMMAND DESCRIPTION AND PARAMETERS
SET_HDCP_ALLOW N1 Enable/disable HDCP encrypted
source support.
Available values for N1:
0 [Disabled]
1 [Enabled]
GET_HDCP Show the current HDCP support state.
SET_USB_MOUSE N1 Set the USB mouse performance
mode.
Available values for N1:
0 [High resolution mode]
1 [Compatibility mode]
GET_USB_MOUSE Show the current USB mouse
performance mode.
SET_BANDWIDTH N1 Set the broadcast stream bandwidth
maximum.
Available values for N1:
0 [50 Mbps]
1 [100 Mbps]
2 [200 Mbps]
3 [400 Mbps]
4 [Best Effort]
SET_FRAME_RATE N1 Set the percentage of frames from
the source video to encode.
N1 = 2~100 [Frame Percent]
SET_VW_OSD N1 {N2} Enable/disable video wall OSD to
display the Target Receiver number
on the designated display.
Available values for N1:
0 [Disable]
1 [Enable]
N2 = 0~255 [Target Rx {Optional}]