CYP CH-U331RX - Page 20

16
5. Receiver Specic
COMMAND DESCRIPTION AND PARAMETERS
SET_OUTPUT_RES N1 43 [1080p@25Hz]
44 [1080p@24Hz]
Note: Downscaling is limited to 1/2
of the horizontal/vertical pixels of
the source. For example: 3840×2160
(4K) to 1920×1080 (1080p) is OK, but
3840×2160 (4K) to 1280×720 (720p) or
640×480 is not. When outputting to a
video wall, the resolution of the entire
video wall together (rather than
each individual display) should be
used for this calculation.
SET_VW N1 Enable/disable video wall
functionality.
Available values for N1:
0 [Disable]
1 [Enable]
GET_VW Show video wall functionality status.
SET_VW_OSD N1 Enable/disable video wall OSD to
display the Target Receiver number
on the connected display.
Available values for N1:
0 [Disable]
1 [Enable]
GET_VW_OSD Show the current video wall OSD
state.
SET_VW_LAYOUT N1 N2 Set the video wall’s total horizontal
and vertical display count.
N1 = 1~16 [Horizontal display
count]
N2 = 1~16 [Vertical display
count]
GET_VW_LAYOUT Show the video wall’s total horizontal
and vertical display count.