CYP CH-U331RX - Page 21

17
5. Receiver Specic
COMMAND DESCRIPTION AND PARAMETERS
SET_VW_POS N1 N2 Set the position within the video wall
of the display connected to this
Receiver. (Cannot exceed the video
wall’s horizontal and vertical display
count.)
N1 = 0~15 [Row]
N2 = 0~15 [Column]
GET_VW_POS Show the position within the video
wall of the display connected to this
Receiver.
SET_VW_BC N1 N2 N3 N4 Set the video wall bezel
compensation values for the display
connected to this Receiver.
N1 = 0~99999 [Video width]
N2 = 0~99999 [Total display width]
N3 = 0~99999 [Video height]
N4 = 0~99999 [Total display height]
GET_VW_BC Show the video wall bezel
compensation values for the display
connected to this Receiver.
SET_VW_HSCALE N1 Set the horizontal zoom amount
of the display connected to this
receiver.
N1 = 0~99999 [Zoom amount in 1
pixel units]
GET_VW_HSCALE Show the horizontal zoom amount
of the display connected to this
receiver.
SET_VW_VSCALE N1 Set the vertical zoom amount of the
display connected to this receiver.
N1 = 0~99999 [Zoom amount in 1
pixel units]