CYP CH-U331RX - Page 22

18
5. Receiver Specic
COMMAND DESCRIPTION AND PARAMETERS
GET_VW_VSCALE Show the vertical zoom amount
of the display connected to this
receiver.
SET_VW_SHIFT N1 N2 Set the video output shift of the
display connected to this receiver.
Available values for N1:
U [Shift up]
D [Shift down]
L [Shift left]
R [Shift right]
N2 = 0~80000 [Pixel shift amount.
Must be in increments
of 8]
GET_VW_SHIFT Show the video output shift of the
display connected to this receiver.
SET_VW_DELAY N1 Set the video delay of the display
connected to this receiver.
N1 = 0~99999 [Delay in
microseconds]
GET_VW_DELAY Show the video delay of the display
connected to this receiver.
6. Serial
COMMAND DESCRIPTION AND PARAMETERS
SET_SERIAL_ALLOW N1 Enable/disable Serial bypass support.
Available values for N1:
0 [Disabled]
1 [Enabled]
GET_SERIAL_ALLOW Show the current Serial bypass
support state.