13
6.4 Remote Control
1
Analyser/Pattern: Press to switch
between Analyser Mode and Pattern
Mode.
2
EDID: Press repeatedly to switch between
the available EDIDs for the HDMI input.
3
Color Space: Press repeatedly to switch
between the available colour space
formats (RGB, YCbCr 4:4:4, YCbCr 4:2:2 &
YCbCr 4:2:0).
4
HDCP SW.: Press to switch between
supported HDCP versions or to disable
HDCP.
5
Format: Press to switch between DVI and
HDMI output formats.
6
VGA~4K6G: Press to directly select the output resolution.
7
Output On: Press to enable video output.
8
Output Off: Press to disable video output.
9
T− & T+: Press
◄/►
to select a new output resolution timing. Within
the OSD menu, press to adjust selections.
P+ & P−: Press
▲/▼
to change the current test pattern. Within the
OSD menu, press to move up and down.
OK: After selecting a pattern, press and hold for 2 seconds to switch
to alternate variations of the pattern. Within the OSD menu, press to
confirm selections.
10
Menu: Press to enter the OSD menu.
11
Exit: Press to exit the OSD or cancel the selection.
12
For use in Analyser Mode only:
Source: Press to display source signal information on the OSD.
Video T: Press to display video analysis details on the OSD.
Audio T: Press to display audio analysis details on the OSD.
CR-174
OK
Output On
Pattern
Analyser/
HDCP SW.
Output Off
Color Space FormatEDID
T+
Menu
P+
Exit
P
-
T
-
Audio CH HotplugPacket
Sink AVMute1 AVMute0
Source Audio T.Video T.
VGAWXGA WUXGA
480p 720p 1080p
1080i4K3G 4K6G
Vol+Vol-Mute
1
2
7
6
9
10
12
13
4
5
To Next Page
Loading...