CYP XA-4 - Factory Default; Power-On Reset

18
ANALYSER MODE
LEVEL 1 LEVEL 2 LEVEL 3
Setup Information Refresh 1 Sec ~ 2 Sec (2 Sec)
Manual
IR Controller Address 0 ~ 3 (0)
Copied EDID Reset No/Yes
Ethernet Reset No/Yes
Factory Reset No/Yes
Information [Unit Version Details]
i
Factory Default
-
Items in Bold are the factory default settings.
i
Power-On Reset
-
Settings marked with *PoR are reset to the default when the unit is
powered off and back on.
i
Source HDR Ability
-
Parse the HDR Static Metadata data block in the sink's EDID.
-
Output 4K60 (4:2:0, 10/12-bit), or 4K30 (4:4:4, 10/12-bit).
-
Output DRMI (Dynamic Range & Mastering InfoFrame).
i
Sink HDR Ability
-
Build an RX EDID that includes the HDR Static Metadata data block.
-
Receive 4K60 (4:2:0, 10/12-bit), or 4K30 (4:4:4, 10/12-bit) signals.
-
Receive DRMI and decode the HDR contents.
i
Unit HDR Capabilities & Limitations
-
Support HDR bypass & analysis in Analyser mode.
-
HDR EDID must be copied from an connected sink to the RX EDID
through the EDID Emulator menu in Analyser mode.
-
EDID Analyser & DRMI Packet Monitor for HDR analysis in Analyser
mode.
-
Output emulated HDR metadata to test sink HDR detection in Pattern
mode.