Cypress Traveo II - Operation Points and Locations; Power Supply

Traveo II Starter Kit User Guide, Document Number: 002-25314 Rev. *B 10
Overview
Table 2-1. Traveo II Starter Kit Functions
Item Function Specification Remarks
Traveo II
Starter Kit
MCU
CYT2B75XX
CYT2B95XX
U1: QFP 100-pin (0.5-mm pitch)
Oscillator
(optional)
Main clock 16 MHz
Surface mounted main crystal
oscillator and load capacitances
(10 pF)
X1: ABM10-16.000MHZ-D30-T3
PSoC 5LP Kit-
Prog3
CY8C5868LTI-LP039 U2: QFN 68-pin
Reset SW System reset switch SW2
User SW User switch connects to MCU SW1
Mode SW Mode switch connects to PSoC SW3
User LEDs
Two User LEDs connected to
MCU
LED1 Blue
LED4 Blue
Power LED Power monitor LED LED2 Green
Status LED KitProg3 status LED LED3 Amber
USB connector USB micro connector J8: 10118194-0001LF
CAN FD interface
CAN FD channel
CAN0_1
J5: CAN0_1 (Screw Terminal)
U3: TJA1057GT
Potentiometer Potentiometer 10 kΩ VR1: 3313J-1-103E
Arduino compati-
ble pin headers
Header 2.54-mm pitch 8 x 1 J1, J2, J7, J9, J10
Header 2.54-mm pitch 10 x 1 J11
Header 2.54-mm pitch 18 x 2 J13
Debug connector
(optional)
MIPI-10/20 Arm JTAG
J3: FTSH-110-01-L-DV-K
Not mounted by default