To Next PageTo Next Page
Need help?Do you have a question about the Cypress Traveo II and is the answer not in the manual?
General| Flash Memory | Up to 8 MB |
|---|---|
| RAM | Up to 1 MB |
| ADC Resolution | 12-bit |
| DAC Resolution | 12-bit |
| Operating Temperature | -40°C to +125°C |
| Timers | Multiple 16-bit and 32-bit timers |
| Architecture | ARM Cortex-M |
| Communication Interfaces | CAN FD, SPI, I2C, UART |
| Package | LQFP, BGA |
| Security Features | Secure Boot |
Provides critical safety information to prevent hazards during product use.
Lists other relevant technical reference documents for the Traveo II Starter Kit.
Provides information on document currency and update policies.
Identifies the specific product targeted by this evaluation board.
Provides critical safety information to prevent hazards during product use.
Details the board's functions and its role as an evaluation environment.
Explains power input, distribution, and current measurement setup.
Describes the 16-MHz oscillator and its load capacitance.
Details the function and location of user, reset, and mode switches.
Identifies LEDs for power, status, and user indication with pin mapping.
Covers the USB micro connector for programming and debugging.
Details the optional CAN FD interface connector and its pinout.
Describes the 10 kΩ potentiometer and its connection to the ADC.
Lists pin assignments for all Arduino-compatible headers for I/O access.
Explains the MIPI-10/20 connector for debugging via SWD.
Lists specific limitations of the Traveo II Starter Kit and potential workarounds.
Details the physical connections and pin assignments for board components.
Maps board LEDs to MCU pins for status indication.
Details the user switch connection to the MCU.
Explains the reset switch connection to the MCU.
Describes the mode switch connection to the PSoC 5LP.
Provides detailed circuit diagrams of the Traveo II Starter Kit components.
Shows the physical component placement on the PCB top and bottom views.
