Cyrus Stream X2 - Advanced Setup Options; Audio Balance and Factory Reset; n-remote Pairing and Language Settings; System Information and About Section

Cyrus Streamline
2
series User Instructions
12
Setup - Balance
You can adjust the left/right channel balance with this option.
Select the Balance option from the Setup menu.•
A balance setting scale is displayed.
Turn the Volume/select control to change the balance setting in + •
or - 1dB steps.
The final step will set the balance completely to left or right.
NOTE: When setting balance from an n-remote, press the  button to
move the balance right and the  button to move the balance left.
Setup - Factory Reset
The factory reset option will reset all settings to ‘factory original’.
NOTE: All settings will be reset including network settings, input names,
etc. A paired n-remote will not be unpaired after a reset.
Select the Factory reset option from the Setup menu.•
A confirmation prompt is displayed.
Choose ‘Yes’ if you want to proceed with a reset.•
All stored settings will be erased when the unit is next set to Standby.
Setup - n-remote
This option will pair or unpair an n-remote.
Pairing an n-remote
Refer to the Getting Started section of the n-remote instructions for the
pairing procedure.
Unpairing an n-remote
If necessary, you can unpair all n-remotes from a Streamline
2
.
NOTE: If you unpair all n-remotes, there will be no remote control
associated with the Streamline
2
.
Press the •
key on the front panel repeatedly to return to the Main
Menu.
Select the Setup option from the Main Menu.•
The Setup Menu is displayed.
Select the n-remote option from the Setup Menu.•
Highlight and select the Unpair n-remotes option.•
‘Unpaired all devices’ will be displayed to confirm that any paired
n-remotes have been unpaired..
Setup - Language
You can change the Language for the Streamline
2
display menus.
Select the Language option from the Setup menu.•
The languages available will be listed.
Select your preferred language.•
The menu language will change.
NOTE: This will also change the language of Streamline
2
menus displayed
on an n-remote.
NOTE: The language of albums, titles and artists etc will not be changed
with the language setting. The Streamline
2
will always display this
information in the language stored with the music file.
Setup - About
Choose this option to display information about the firmware installed
in the Streamline
2
. You may be asked for this information if you contact
Cyrus for service or support of your system at any time.