3.6 TK3 Power Supply System Recycling Tutorial
3.6.1 Adjust the strength of Cable retrieve to “Medium” and control UAV to
make it descend at a speed of 1 m/s .
3.6.2 The UAV descend and hover at a height of 3m above the ground, turn
off the lights, close the Cable retrieve and turn off the power output.
3.6.3 The drone land on the ground, stop the oars and shut down.
3.6.4 Unplug the LP12 aviation plug. (please note that the “power On / Off”
on “Off” state is confirmed before pulling out the LP12 aviation plug)
3.6.5 Disassemble the hanging wire hook as shown in the figure.
67
To Next Page
Loading...