4
• Users with DSL providers - If you are using a PPPoE connection, you will need
your PPPoE user name and password. If you do not have this information, contact
your Internet provider. Do not proceed until you have this information.
• Users with Cable providers - Make sure you unplug the power to your modem.
In some cases, you may need to turn it o for up to ve minutes.
• Advanced Users - If your ISP provided you with a modem/router combo, you will
need to set it to “bridge” mode so the DIR-895L router can work properly. Please
contact your ISP or refer to the user manual for your modem/router device.
Before You Start
1
Attach the eight antennas to the router by twisting them on clockwise.
Connect your Router
Note: If you experience issues registering this device with your mydlink account, or if you
purchased an open box or resold unit, perform a hard reset by pressing and holding the reset
button on the device for 10 seconds while the device is powered on. If you are returning the
device, please perform the hard reset procedure to clear the device of any personal data.
2
Unplug the power to your DSL or Cable modem.
Modem
To Next Page
Loading...
Need help?
General
