D-Link DAP-1360U

DAP-1360U Quick Installation Guide
Also you can enable the WDS function via the Initial Configuration Wizard.
To do this, on the Device mode page, from the Connection method list,
select the Wi-Fi value. Then from the Work mode list select the WDS value.
In this mode you can specify the WDS function parameters, change the LAN
IP address, set your own settings for the wireless network, and set your own
password for access to the web-based interface of the device.
In order to connect your device to a wired ISP, on the Device mode page,
from the Connection method list, select the Wired connection value.
Then from the Work mode list select the Router value. In this mode you can
configure a WAN connection, set your own settings for the wireless network,
configure LAN ports to connect an STB or VoIP phone, and set your own
password for access to the web-based interface of the device.
In order to connect your device to a wireless ISP (WISP), on the Device
mode page, from the Connection method list, select the Wi-Fi value.
Then from the Work mode list select the WISP Repeater value. In this
mode you can connect your device to another access point, configure a WAN
connection, set your own settings for the wireless network, configure LAN
ports to connect an STB or VoIP phone, and set your own password for access
to the web-based interface of the device.
When the operation mode is selected, click the NEXT button.
17