D-Link DAP-2230 - Configuration Options; Direct Connection; Power;Status LED; LED Overview

D-Link DAP-2230 Quick Install Guide
2
ENGLISH
Conguration
To set up and manage the DAP-2230 use
one of the following methods:
Direct Connection
Connect the access point to your computer
and plug in the power adapter.
Ensure your computer is congured with
a static IP address in the 192.168.0.0/24
subnet range.
Launch a web browser, type the
default IP address of the access point
(http://192.168.0.50) and then press Enter.
To Log in to the Administration Web page,
the default login information is:
Username: admin
Password: (Leave the password eld
blank)
Connect via Network Switch
Connect the access point and your
computer to the same switch.
Launch a web browser, type the
default IP address of the access point
(http://192.168.0.50) and then press Enter.
To Log in to the Administration Web page
the default login information is:
Username: admin
Password: (Leave the password eld
blank)
OR
PoE Switch
DAP-2230
Computer
Power
Adapter
Conguration Options
Computer
LED Overview
Power/Status LED
- Flashing Red: Malfunction during boot up
- Static Green: Ready/working
- Solid Red: Boot up failure
- Flashing Green: Trafc is passing through
Switch