Need help?Do you have a question about the D-Link Nuclias Connect DAP-2610 and is the answer not in the manual?
General| Wireless Standard | IEEE 802.11a/b/g/n/ac |
|---|---|
| Frequency Band | 2.4 GHz, 5 GHz |
| Antenna Type | Internal |
| PoE Support | 802.3af PoE |
| Management | Nuclias Connect |
| Operating Humidity | 10% to 90% non-condensing |
| Ethernet Ports | 1 x Gigabit Ethernet |
| Security | WPA/WPA2 |
| Operating Modes | Access Point, Wireless Distribution System (WDS), WDS with AP, Wireless Client |
| Mounting | Wall, Ceiling |
| Operating Temperature | 0 to 40 °C |
Describes the LED indicators for power and status.
Details the physical ports for power and network connection.
Explains the methods to power on the DAP-2610.
Illustrates the basic hardware connections for setup.
Configures advanced wireless performance parameters like data rate and beacon interval.
Configures the AP to create a wireless LAN.
Explains WEP encryption with Open System and Shared Key.
Displays current VLAN configurations and status.
Configures captive portal for web redirection authentication.
Configures the IP address pool for dynamic assignments.
Configures Wireless MAC Access Control Lists for filtering.
Configures downlink and uplink bandwidth rates for interfaces.
Displays wired interface network traffic statistics for packets and bytes.
Displays system and network messages with timestamps and types.
Controls administrator access based on VLAN ID.
Controls administrator access based on IP address range.
To Next Page
