D-Link Nuclias Connect DAP-2610 User Manual

D-Link DAP-2610 User Manual
36
Intrusion
The Wireless Intrusion Protection window is used to set your APs to All, Valid, Neighborhood, Rogue, and New. Click the Save button to let
your changes take eect.
Wireless Band:
Detect:
AP List:
Save:
Select 2.4GHz or 5GHz.
Click this button to initiate a scan of the
network.
Click the drop-down menu to select All,
Valid, Neighbor, Rogue, and New. The
following is a denition of the listed AP
categories:
Valid: An AP which is authenticated to
the network with encryption is classied
as valid.
Neighbor: A detected AP with a weak
signal strength is classied as a suspect
neighbor.
Rogue: An AP that has been installed
on the secure network without explicit
authorization.
New: An alternative category.
From the AP List, select a detected
AP and click Set as Valid, Set as
Neighborhood, Set as Rogue, or Set
as New to manually dene the category
type for the AP. Alternatively, click the
radio button to mark all new access
points as valid or rogue.
Click to save the updated conguration.
To make the updates permanent, click
Conguration > Save and Activate.

D-Link Nuclias Connect DAP-2610 Specifications

General

Wireless Standard	IEEE 802.11a/b/g/n/ac
Frequency Band	2.4 GHz, 5 GHz
Antenna Type	Internal
PoE Support	802.3af PoE
Management	Nuclias Connect
Operating Humidity	10% to 90% non-condensing
Ethernet Ports	1 x Gigabit Ethernet
Security	WPA/WPA2
Operating Modes	Access Point, Wireless Distribution System (WDS), WDS with AP, Wireless Client
Mounting	Wall, Ceiling
Operating Temperature	0 to 40 °C