6 DAP-2690 Install Guide
To power the access point, you can use one of the following 3 methods:
Method 1 - Use if you have a PoE switch.
Method 2 - Use if you do not have a PoE switch and do not
have a power outlet near the location of the access
point.
Method 3 - Use if you do not have a PoE switch and have a
power outlet near the location of the access point.
Method 1
1. Connect one end of your Ethernet cable into the LAN (PoE) port on the
DAP-2690.
2. Connect the other end into one port on a PoE switch.
To Next Page
Loading...
