DAP-400P Quick Installation Guide
PC with Wi-Fi Adapter
1. For a switch supporting PoE: connect an Ethernet cable between the
PoE-enabled switch and the WAN port of the access point.
2. For a switch not supporting PoE or router: connect an Ethernet cable
between the switch or router and any Ethernet port of the access point.
3. Connect the power adapter (not included in the delivery package) to the
power connector port on the back panel of the access point, then plug the
power adapter into an electrical outlet or power strip.
4. Make sure that the Wi-Fi adapter of your PC is on. As a rule, modern
notebooks with built-in wireless NICs are equipped with a button or
switch that turns on/off the wireless adapter (refer to your PC
documents). If your PC is equipped with a pluggable wireless NIC, install
the software provided with your Wi-Fi adapter.
Now you should configure your Wi-Fi adapter.
10
To Next Page
Loading...
Need help?
General
