DAP-400P Quick Installation Guide
Configuring Local Area Network
1. Go to the Connections Setup / LAN page.
2. If needed, change the IPv4 address of the access point's LAN interface
and the mask of the local subnet. To do this, click the IPv4 tab and
specify needed values in the IP address and Mask fields in the Local
IP Address section.
3. If needed, change the static IPv6 address of the access point's LAN
interface. To do this, click the IPv6 tab. In the Local IPv6 Address
section, left-click the line of the IPv6 address. In the opened window,
specify needed values in the IPv6 address and Prefix fields and click
the APPLY button.
36