D-Link DCS-5220 Quick Install Guide

5 D-Link DCS-5220 Quick Install Guide
Hardware Installation
Connect an Ethernet cable to the
Ethernet connector located on the
Internet Camera’s back panel and
attach it to the network.
Note: It is required that an Ethernet
cable is used during initial setup.
Once your wireless configuration is
set, you may disconnect the Ethernet
cable and begin communicating
wirelessly with your DCS-5220.
Attach the external power supply
to the DC power input connector
located on the Internet Camera’s
back panel (labeled DC 12V) and
connect it to an AC power outlet.
Hardware Installation

D-Link DCS-5220 Specifications

Operating Environment

operating temperature	0˚ to 40˚C (32˚- 104˚F)
storage temperature	-40˚ to 70˚C (-14˚ - 158˚F)
humidity	Max. 95% RH

Power

external power supply	12V DC 1.5A
power consumption	4.8 Watts

Camera Specifications

cmos sensor	1/4”
minimum illumination	0.5 Lux @ F2.0
viewing angle horizontal	270º
viewing angle vertical	90º

Video and Audio

video resolution at 160x120	Up to 30fps
video resolution at 176x144	Up to 30fps
video resolution at 320x240	Up to 30fps
video resolution at 640x480	Up to 30fps
audio bitrate AAC	16kbps~128kbps
audio bitrate GSM-AMR	4.75kbps~12.2kbps

Weight and Dimensions

width	4.1”
height	4.4”
depth	4.3”
item weight	0.7 lbs
packaging weight	2.9 lbs