16D-Link DCS-8620LH User Manual
Section 3 - mydlink
1 Device Name Tap to change the device’s name.
2 Privacy Mode Tap to enable. Privacy mode will disable the camera feed.
3 Motion and Person Detection Tap to set the Motion and Person Detection sensitivity settings.
4 Vehicle Detection Sends notications when vehicles are detected (within 50 feet of the camera view).
5 Siren Timeout
Set the auto-off timer for the siren. This setting will apply to manual operation and
Automations.
6 Storage
Tap to change the video clips storage location from the microSD card to the cloud. You can
also subscribe to mydlink Cloud from here and view your current subscription plan.
7 Camera Microphone Tap to enable or disable picking up sound near your camera in live view and recordings.
8 Color Night Vision
Tap to change night vision detection to On, O or Auto. Color Night Vision is enabled by
default and allows you to see color images while viewing the live feed in low
light scenarios.
9 Anti-Flicker Reduces icker in the video. Tap 50 Hz or 60 Hz depending on the frequency of your lights.
10 Status LED Disabling this to turn o LED indicators.
11 Designated Contact
Tap to add, remove, or edit designated contacts for quick phone call upon receiving a
notication.
12 Wi-Fi
Tap to change the wireless network this device will use to connect to the Internet.
Note: The network must be the same as all your other mydlink devices that you wish to use
the same account for.
13 Time Zone Select the time zone to calibrate your device to.
14 Firmware
This displays the installed version of the rmware on your device. Tap to enter the update
settings. You can choose the most suitable time for automatic updates.
15 ONVIF Tap to enable ONVIF to allow ONVIF-compatible devices to manage the camera.
16 MAC ID A unique physical address for identifying your device.
17 Restart Device Tap this button to restart the device
18 Remove Device Tap this button to disconnect this device from your mydlink account.
3
1
2
4
5
6
7
8
9
10
11
17
18
16
15
12
13
14
1
3