To Next Page

To Previous Page

Hardware Installation

Attach the Swivel Stand

Locate the stand mount on the bottom panel of the DCS-900 and screw on the swivel stand to the base of the DCS-900.

Connect the Ethernet Cable

Connect the included Ethernet cable to the network cable connector located on the back panel of the DCS-900 and attach it to the network. Network connectivity is

confirmed when the green LED Indicator on the DCS-900, located below the Power LED, is illuminated.

Attach the External Power Supply

Attach the external power supply to the DC power input connector located on the rear panel of the DCS-900 and connect it to a wall outlet or power strip.

NOTE:

Power source is confirmed when the red LED Power Indicator located to the right of the lens on the DCS-900 is illuminated.