10/100 Dual-Speed Switch User’s Guide
12
Unpacking and Setup
♦
Select a site that is free of obstructions from other equipment
or devices. Consider the following points for site selection:
◊
The Switch should be placed high enough where LED
indicators can be observed and cable and power
connections can be made.
◊
Moreover, decide whether you would like the switch to
point with the front panel facing either up or down.
♦
Drill two holes into the wall with the same distance as the
screw support holes located on the bottom of the switch. Do
not drill these holes too deep.
♦
Insert the nylon anchors into the holes in the wall and imbed
them with gentle taps of a hammer.
♦
Screw in the screws provided with the wall mount kit into
the plastic anchors. Do not insert the screws with excessive
torque. The screw’s head and with a small portion of the
screw’s body should be sticking out.
♦
Gently, place the switch onto the wall with the front panel
facing up or down by sliding the screws into the provided
slots.
♦
Make all power and network connections at this time (for
more information see Chapter 4, Connecting the Switch).
To Next Page
Loading...
