Command: show
Next possible completions:
802.1p 802.1x access_profile account
acct_client address_binding arp_spoofing_prevention
arpentry asymmetric_vlan auth_client auth_diagnostics
auth_session_statistics auth_statistics authen
authen_enable authen_login authen_policy auto_fdb
autoconfig bandwidth_control bpdu_protection bpdu_tunnel
command command_history config cos
cpu_access_profile cpu_filter dhcp_local_relay
dhcp_relay dos_prevention dscp_mapping error
fdb filter firmware flood_fdb
flow_meter gratuitous_arp greeting_message gvrp
igmp igmp_snooping ipif iproute
jumbo_frame lacp_ports link_aggregation lldp
log log_save_timing loopdetect mac_notification
mirror multicast multicast_fdb packet
per_queue port_security ports pppoe
pvid radius router_ports safeguard_engine
scheduling scheduling_mechanism serial_port
session smtp snmp sntp
ssh stp switch syslog
tech_support terminal_line time traffic
traffic_segmentation trusted_host utilization
vlan vlan_trunk
DES-1228/ME:5#
Figure 2 - 6. Next possible completions: Show Command
In the above example, all of the possible next parameters for the show command are displayed. At the next command prompt, the
up arrow was used to re-enter the show command, followed by the account parameter. The CLI then displays the user accounts
configured on the Switch.
To Next Page
Loading...
