D-Link DES-1228/ME - Port Configuration

DES-1228/ME Metro Ethernet Managed Switch CLI Reference Guide
37
6
SWITCH PORT COMMANDS
The Switch Port commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table:
Command Parameters
config ports [<portlist> | all] {medium_type [fiber | copper]} {speed [auto | 10_half | 10_full | 100_half
| 100_full | 1000_full {[master | slave]}] | flow_control [enable | disable] | state [enable |
disable] | learning [enable | disable] | [description <desc 32> | clear_description] | mdix
[auto | normal | cross]} (1)
show ports {<portlist>} { [description | err_disabled] }
Each command is listed, in detail, in the following sections: