D-Link DES-1228/ME - Bpdu Attack Protection Commands

DES-1228/ME Metro Ethernet Managed Switch CLI Reference Guide
367
47
BPDU ATTACK PROTECTION COMMANDS
The BPDU Attack Protection commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters)
in the following table.
Command Parameters
config bpdu_protection ports [<portlist> | all ] {state [enable | disable] | mode [ drop | block |
shutdown } (1)
config bpdu_protection recovery_timer [<sec 60-1000000> | infinite]
config bpdu_protection [ trap | log ] [ none | attack_detected | attack_cleared | both ]
enable bpdu_protection
disable bpdu_protection
show bpdu_protection { ports {<portlist> } }
Each command is listed, in detail, in the following sections:
Note
: The BPDU Attack Protection function and Spanning Tree Protocol for ports are mutually
exclusive. When the STP function is enabled on a particular port, BPDU Attack Protection cannot be
enabled. If BPDU Attack Protection function is enabled on a port, BPDU cannot be forwarded.