D-Link DES-1228/ME - Page 105

DES-1228/ME Metro Ethernet Managed Switch CLI Reference Guide
101
show syslog host
Purpose
Used to display the syslog hosts currently configured on the Switch.
Syntax
show syslog host {<index 1-4>}
Description
This command is used to display the syslog hosts that are currently
configured on the Switch.
Parameters
<index 1-4> − Specifies that the command will be applied to an
index of hosts. There are four available indexes, numbered 1
through 4.
Restrictions
None.
Example usage:
To show syslog host information:
DES-1228/ME:5#show syslog host
Command: show syslog host
Syslog Global State: Disabled
Host Id Host IP Address Severity Facility UDP port Status
------- --------------- -------------- -------- -------- --------
1 10.1.1.2 All Local0 514 Disabled
2 10.40.2.3 All Local0 514 Disabled
3 10.21.13.1 All Local0 514 Disabled
Total Entries : 3
DES-1228/ME:5#