D-Link DES-1228/ME - Page 230

DES-1228/ME Metro Ethernet Managed Switch CLI Reference Guide
226
Example usage:
To show the CPU filtering state on the Switch:
DES-1228/ME:5#show cpu_access_profile
Command: show cpu_access_profile
CPU Interface Filtering state: Enabled
Access Profile Table
================================================================================
Profile ID: 1 Type: IPv4 Frame Filter - ICMP
================================================================================
Owner: ACL
Masks Option
VLAN Source IP Dest. IP DSCP Prot Type Code
---------------- --------------- --------------- ---- ---- ---- ----
0xFFF 20.0.0.0 10.0.0.0 ICMP
--------------------------------------------------------------------------------
Access ID : 3
Ports : 1-10
Mode : Deny
VLAN Name Source IP Dest. IP DSCP Prot Type Code
Mask Mask Mask
---------------- --------------- --------------- ---- ---- ---- ----
default (0x1) 20.0.0.0 10.0.0.0 3 ICMP 11 32
================================================================================
Total Profile Entries: 1
Total Rule Entries: 1
enable cpu_interface_filtering
Purpose
Used to enable CPU interface filtering on the Switch.
Syntax
enable cpu_interface_filtering
Description
This command is used, in conjunction with the disable
cpu_interface_filtering command below, to enable and disable CPU
interface filtering on the Switch.
Parameters
None.
Restrictions
Only Administrator level, Operator level or Power User level users can
issue this command.