DES-1228/ME Metro Ethernet Managed Switch CLI Reference Guide
394
debug config error_reboot
Description
Set if the switch needs to be rebooted when a fatal error occurs.
Parameters
enable − Need to reboot the switch when fatal error happens (if the
project does not define the default setting, enable for default).
disable − Does not need to reboot the switch when fatal error
happens, system will hang-up for debug and enter the debug shell
mode for debug.
Restrictions
Only Administrator-level users can issue this command.
Example usage:
To set the switch to not need a reboot when a fatal error occurs:
Command: debug config error_reboot disable
Success.
DES-1228/ME:5#
debug show error_reboot state
Purpose
Use the command to show the error reboot status.
Syntax
debug show error_reboot state
Description
Show the error reboot status.
Parameters
None.
Restrictions
Only Administrator-level users can issue this command.
Example usage:
To show the error reboot status:
To Next Page
Loading...
