D-Link DES-1228/ME

DES-1228/ME Metro Ethernet Managed Switch CLI Reference Guide

39

show ports

Purpose

Used to display the current configuration of a range of ports.

Syntax

show ports {<portlist>} {[description | err_disabled]}

Description

This command is used to display the current configurations of a range of ports. No

parameters will show all ports.

Parameters

<portlist> − Specifies a port or range of ports to be displayed.

description – Adding this parameter to the show ports command indicates that a

previously entered port description will be included in the display.

err_disabled – Use this to list disabled ports including connection status and

reason for being disabled.

Restrictions

None.

Example usage:

To display the configuration of all ports on a standalone switch:

DES-1228/ME:5#show ports

Command: show ports

Port State/ Settings Connection Address

MDI Speed/Duplex/FlowCtrl Speed/Duplex/FlowCtrl Learning

----- -------- --------------------- --------------------- --------

1 Enabled Auto/Disabled LinkDown Enabled