D-Link DES-1228/ME - Page 93

DES-1228/ME Metro Ethernet Managed Switch CLI Reference Guide
89
Each command is listed, in detail, in the following sections:
show packet ports
Purpose
Used to display stats about packets sent and received by the Switch.
Syntax
show packet ports <portlist>
Description
This command is used to display statistics about packets sent and
received by ports specified in the <portlist>.
Parameters
<portlist> − Specifies a port or range of ports to be displayed.
Restrictions
None.
Example usage:
To display the packets analysis for port 1:
DES-1228/ME:5#show packet ports 1
Command: show packet ports 1
Port Number : 1
Frame Size Frame Counts Frames/sec Frame Type Total Total/sec
------------ ------------ ---------- ---------- ---------- ---------
64 0 0 RX Bytes 0 0
65-127 0 0 RX Frames 0 0
128-255 0 0
Port Number : 1 0 TX Bytes 0 0
Frame Size Frame Counts Frames/sec Frame Type Total Total/sec
------------ ------------ ---------- ---------- ---------- ---------
64 0 0 RX Bytes 0 0
65-127 0 0 RX Frames 0 0
128-255 0 0
256-511 0 0 TX Bytes 0 0
512-1023 0 0 TX Frames 0 0
1024-1518 0 0
Unicast RX 0 0
Multicast RX 0 0
Broadcast RX 0 0
CTRL+C ESC q Quit SPACE n Next Page p Previous Page r Refresh