D-Link DES-1228/ME - Page 95

DES-1228/ME Metro Ethernet Managed Switch CLI Reference Guide
91
show utilization
Purpose
Used to display real-time utilization statistics.
Syntax
show utilization [ cpu | dram | flash | ports {<portlist>}]
Description
This command is used to display the real-time utilization statistics for
the Switch.
Parameters
cpu – Entering this parameter will display the current CPU utilization
of the Switch.
dram – Entering this parameter will display the current DRAM
utilization of the Switch.
flash – Entering this parameter will display the current Flash
utilization of the Switch.
ports – Entering this parameter will display the current port utilization
of the Switch.
<portlist> – Specifies a range of ports to be displayed.
Restrictions
None.
Example usage:
To display the current CPU utilization:
DES-1228/ME:5#show utilization cpu
Command: show utilization cpu
CPU Utilization :
------------------------------------------------------------------
Five Seconds - 3% One Minute - 2% Five Minutes - 5%
CTRL+C ESC q Quit SPACE n Next Page p Previous Page r Refresh
To display the current DRAM utilization:
DES-1228/ME:5#show utilization dram
Command: show utilization dram
DRAM Utilization :
Total DRAM : 131,072 KB
Used DRAM : 65,604 KB
Utilization : 50%
CTRL+C ESC q Quit SPACE n Next Page p Previous Page r Refresh