DES-1228/ME Layer 2 Fast Ethernet Managed Switch
1
Section 1
Introduction
DES-1228/ME Switch Description
Features
Ports
LED Indicators
Front-Panel Description
Rear Panel Description
Side Panel Description
Installing SFP ports
DES-1228/ME
The DES-1228/ME is a member of the D-Link Switch family. This Switch provides unsurpassed performance, fault tolerance,
scalable flexibility, robust security, standard-based interoperability and impressive technology to future-proof departmental and
enterprise network deployments with an easy migration path.
The following manual describes the installation, maintenance, and configurations concerning the DES-1228/ME.
Features
• IEEE 802.3ad Link Aggregation Control Protocol support
• IEEE 802.1X Port-based and Host-based Access Control
• IEEE 802.1Q VLAN
• IEEE 802.1D Spanning Tree, IEEE 802.1w Rapid Spanning Tree and IEEE 802.1s Multiple Spanning Tree support
• Access Control List (ACL) support
• Access Authentication Control utilizing TACACS, XTACACS and TACACS+
• Internal Flash Drive for saving configurations and firmware
• Simple Network Time Protocol support
• MAC Notification support
• System and Port Utilization support
• System Log Support
• Support port-based enable and disable
• Address table: Supports up to 8K MAC addresses per device
• Supports a packet buffer of up to 512K bytes
• Supports Port-based VLAN Groups
• Port Trunking with flexible load distribution and fail-over function
• IGMP Snooping support
• SNMP support
• Secure Shell (SSH) support
• Port Mirroring support
• MIB support for:
1. RFC1213 MIB II
2. RFC1493 Bridge
3. RFC2819 RMON
4. RFC2665 Ether-like MIB
5. RFC2863 Interface MIB
6. Private MIB
To Next Page
Loading...
