DES-3000 Series Layer 2 Switch CLI Reference Manual
111
config 802.1p user_priority
service the 802.1p priority value (specified above) will be mapped.
Restrictions Only Administrator-level users can issue this command.
Example usage:
To configure 802.1 user priority on the Switch:
DES-3026:4# config 802.1p user_priority 1 3
Command: config 802.1p user_priority 1 3
Success.
DES-3026:4#
show 802.1p user_priority
Purpose Used to display the current mapping between an incoming packet’s
802.1p priority value and one of the Switch’s four hardware priority
classes of service.
Syntax
show 802.1p user_priority
Description
The show 802.1p user_priority command displays the current
mapping of an incoming packet’s 802.1p priority value to one of the
Switch’s four hardware priority classes of service.
Parameters None.
Restrictions None.
Example usage:
To show 802.1p user priority:
DES-3026:4# show 802.1p user_priority
Command: show 802.1p user_priority
QOS Class of Traffic
Priority-0 -> <Class-1>
Priority-1 -> <Class-0>
Priority-2 -> <Class-0>
Priority-3 -> <Class-1>
Priority-4 -> <Class-2>
Priority-5 -> <Class-2>
Priority-6 -> <Class-3>
Priority-7 -> <Class-3>
DES-3026:4#
To Next Page
Loading...
